[4 pc] Pressure Sensor, Silicon Transducer, 0-300mm Hg rel

Description

Beware of Chinese sellers, especially those who claim "USA Seller" or "Ships from USA". They send Chinese junk to agents in USA for re-shipment to you. Check seller country by clicking on the feedback number and checking the line "
Member since..."
PressureTransducer
Pressure Sensor / Transducer, 0-300mm Hg, relative to ambient
Case: 6mm
Lot Size: 4 units
Pressure response: 0-300mm Hg (0-40kPa)
Motorola Part MPX2301DT1 (now Freescale Semiconductor)
New, in sealed tape reel
You connect a flexible tube to the sensor's inlet port, and it measures the pressure in the tube. A hermetic gel protects the semiconductor wafer from contaminants in the medium to be measured.
RELATIVE measurement:  senses the pressure on the nozzle side of the device relative to the pressure on the back of the silicon chip.
So if you were to seal off the nozzle with a non-flexible plug, device would sense the pressure behind the chip as an absolute measurement, (having as baseline the ambient pressure at the moment the nozzle was plugged.)
Hookup is, (from left):  VCC, Out+, Out-, GND.
You can find application info on the web.
All pressure sensors are essentially a Wheatstone Bridge on a silicon wafer
You apply a clean DC voltage at the top and bottom nodes of the bridge, and you measure the differential voltage at the remaining 2 middle nodes. Best done by feeding these to the +/- inputs of an opamp or instrumentation (differential) amp.
A typical application (for a different sensor, pinout has different order, but same connections)
If you look at all application schematics ( many are for rocket altimeters, by hobbyists) you see a common denominator: 2 pins to a DC voltage, 2 pins to an op-amp's differential inputs.
NB. Avoid using any schematic that mentions the Motorola MPX4xxx or 5xxx series, as these are Absolute pressure sensors, and have different pin assignments, different implementation.
NOTE: The silicon die and gold wire bonds are exposed on the back of the device. Application mounting must ensure mechanical protection from this side. Simply mounting the part flat on a PCB, as in the top photo will provide that protection.>
I only ship to buyer's EBAY shipping address
Purchases can only be changed or cancelled before payment.
Best Genuine USA parts from USA distribution.
Avoid Chinese counterfeit parts and Chinese seller problems!
Transit time 5-7 bus days in USA, however USPS does not guarantee these times, and can exceed them. If you have any time constraints, contact seller before bidding / buying, so we can both come to an agreement.
No cancellation possible after Payment.  PAYMENT CLOSES ORDER AND COMMITS IT FOR SHIPPING. Your shipping label is created and billed along with insurance the moment you click "PAY". Paypal and insurance charges are non-recoverable.
Any returns not resulting from seller wrongdoing will be assessed a restocking fee of 18% and will forfeit shipping costs.
International transit times can reach 8 weeks, 10 weeks for Italy and Brazil. You need to contact seller for alternate shipping options at extra cost if this is not acceptable to you.